Since I have new extruder I will make some tips using my makins extruder. So say hi to Mr. Extruder, that’s the way I called him. He helped me a lot in many design even-though my hand are kinda hurt using it. I would say it’s not bad if you spend some money to buy a good quality tools coz you will find it worthy.
Materials I used:
Fimo Clay
Makins Extruder
Clay Roller or Pasta Machine
Circle Cutter
Cutter knife
Here’s what I’m gonna share using Mr. Extruder for easy using it.
*First we need a pasta machine or clay roller so we can condition our clay very well.
*After conditioning your clay, use your circle cutter and put them together (like the photo below);
(Yes i know it will eat a lot of time, but don’t worry this will help you to chose your own colors and for easy putting your clay on the extruder)
*Oh my don’t forget to roll your clay when you are done putting them all so your clay will stick together and make them long.
*Then check it if they will already fit on your extruder.
*Put your clay and choose your prefer disc design.
*And we’re all ready to rock! 🙂
*by the way, if your hand are also hurting while using extruder you can use;
–CLOTH GLOVES
–CLOTH TOWEL and roll it to your extruder or;
–RUBBER BAND (more rubber band that will fit your hand when holding Mr. Extruder body)
–FABRIC TAPE
-but the most comfy to use; look for a FOAM it will less the pain since Mr. Extruder are made out of steel. (put and roll it to Mr. Extruder body and the rotator as well if you want)
![]() |
I’M READY TO PUT THEM TOGETHER |
HERE’S MY READY MAKE USING THE SQUARE DISC I JUST PUT THEM TOGETHER SO IT WILL LIKELY BIG.
These are the result of my handmade cane using Mr. Extruder.
I made a ring and a necklace (sorry i forgot to take a pic of my hand made necklace)
Don’t fear to experiment on your own extruder.
Make it ROCK! 😀